私のインターネット接続は有線LAN(イーサネット)で頻繁に切断されますが、ワイヤレスは問題なく正常に動作します。インターネットはWindowsで正常に機能するため、インターネット速度の問題ではありません。
ifconfig出力
$ ifconfig eth0
eth0 Link encap:Ethernet HWaddr 44:1e:a1:db:95:d9
inet addr:192.168.28.127 Bcast:192.168.31.255 Mask:255.255.252.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:31254 errors:0 dropped:0 overruns:0 frame:0
TX packets:1922 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2729623 (2.6 MiB) TX bytes:228959 (223.5 KiB)
Interrupt:41 Base address:0x4000
ethtool出力
$ ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
。
lspci出力
$ lspci -kd 10ec:8136
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 05)
Subsystem: Hewlett-Packard Company Device 1670
Kernel driver in use: r8101
dmesg出力http://Pastebin.com/5rWAuFkH
私は試した:
しかし、問題は解決しません。誰かがこれで私を助けることができますか?.
[〜#〜] edit [〜#〜]完全なifconfig出力
$ ifconfig
eth0 Link encap:Ethernet HWaddr 44:1e:a1:db:95:d9
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:153899 errors:0 dropped:0 overruns:0 frame:0
TX packets:10625 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:16405299 (15.6 MiB) TX bytes:3355393 (3.1 MiB)
Interrupt:41 Base address:0x4000
eth1 Link encap:Ethernet HWaddr 94:39:e5:51:81:49
inet addr:192.168.235.102 Bcast:192.168.235.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4213 errors:0 dropped:0 overruns:0 frame:59354
TX packets:4797 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2795494 (2.6 MiB) TX bytes:712585 (695.8 KiB)
Interrupt:16
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:28 errors:0 dropped:0 overruns:0 frame:0
TX packets:28 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1400 (1.3 KiB) TX bytes:1400 (1.3 KiB)
vmnet1 Link encap:Ethernet HWaddr 00:50:56:c0:00:01
inet addr:172.16.222.1 Bcast:172.16.222.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
vmnet8 Link encap:Ethernet HWaddr 00:50:56:c0:00:08
inet addr:172.16.31.1 Bcast:172.16.31.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
EDIT2
VmWareネットワーク構成
注:これらはデフォルトの構成であり、変更していません。 VMを追加しました。
vmnet0
vmnet1
vmnet8
私の疑惑は、あなたのdmesg出力の次の行によって引き起こされます:
[ 112.906696] bridge-eth0: disabling the bridge on dev down
[ 112.906765] bridge-eth0: down
[ 112.906779] bridge-eth0: detached
[ 113.106574] userif-3: sent link down event.
[ 113.106584] userif-3: sent link up event.
[ 114.910231] r8101: eth0: link up
[ 114.910591] /dev/vmnet: open called by PID 3068 (vmnet-bridge)
[ 114.910628] /dev/vmnet: hub 0 does not exist, allocating memory.
[ 114.910697] /dev/vmnet: port on hub 0 successfully opened
[ 114.910724] bridge-eth0: up
[ 114.910759] bridge-eth0: attached
私は次のことを試してみます。それはただの試みです。それが望ましい結果をもたらさない場合は、PCの電源をオフにしてから再度オンにするだけで、試用前と同じ状況になります。
我々に教えてください。